SATO CL4NX Programming Reference Manual page 47

[Supplementary Explanation]
• When the print start position exceeds the printing area, the printing is not performed. (This will
not be a command error.)
• Set line width according to the table below so the horizontal line width is more than 0.166 mm.
203 dpi (8 dots/mm)
305 dpi (12 dots/mm)
609 dpi (24 dots/mm)
• If setting the vertical line width wider, it will be widened to the right side against media feed
direction. If setting the horizontal line width wider, it will be widened to the lower side against
media feed direction.
• If setting the grid line wider, it will be widened inward.
[Valid Range]
Model
CL4NX
CL6NX
*1 Valid range when "Head Base Position" is set to "Standard".
*2 Valid range when "Head Base Position" is set to "Left-justify".
Parent topic Modification Command
Head density
Head density
203 dpi
305 dpi
609 dpi
203 dpi
305 dpi
45
Line width
2 dots or more
2 dots or more
4 dots or more
Valid range:
Horizontal (dots)
1 to 832
1 to 1248
1 to 2496
*1
1 to 1216
*2
1 to 1340
*1
1 to 1984
*2
1 to 2010
Valid range:
Vertical (dots)
1 to 20000
1 to 18000
1 to 9600
1 to 20000
1 to 18000