[Esc+Ip0] Epc Code Write (Uhf M6E) (Cl4Nx Only) - SATO CL4NX Programming Reference Manual

[ESC+IP0] EPC code write (UHF M6e) (CL4NX Only)

Command
Hexadecimal code
Initial Value
Valid range and term of
command
[Function]
This command writes the EPC code and other data to the EPC corresponding RFID tag. The
standard format (three-character parameter identifier) is used when using the memory area
extended for each IC chip manufacturer.
Available in M6e module installed printers.
[Format]
[Standard format]
<IP0>e:h(,pcw:xxx)(,epc:xxxx...xxxx)(,usr:xxxx...xxxx)|(,usa:dddd,aaaaa...aaaa)(,lck:bbbbb);
[Conventional format]
[SSCC96 code conversion]
<IP0>e:a,c:d,s:d,d:ddddddddddddd(,o:xxx)(,m:bbbbb)(,k:xxxxxxxx)(,a:xxxxxxxx)(,p:xxxxxxxx);
[SGTIN96 encoding]
<IP0>e:c,f:d,c:d,t:d,d:ddddddddddddddddd,n:dddddddddddd(,o:xxx)(,m:bbbbb)(,k:xxxxxxxx)(,a:xxxxxxxx)
(,p:xxxxxxxx);
[Free mapping]
<IP0>e:z(,d:xxxxxxxxxxxxxxxxxxxxxxxx)(,u:xxxxxxxxxxxxxxxx)(,k:xxxxxxxx)(,a:xxxxxxxx)
(,p:xxxxxxxx)(,o:xxx)(,m:bbbbb)(,k:xxxxxxxx)(,a:xxxxxxxx)(,p:xxxxxxxx);
* Typical parameters are shown in the format examples above. Refer to the next item for details on
the parameters.
[Conventional format] is solely for maintaining compatibility with models before CL4NX. For
commands newly created for the CL4NX and later models, please create with the [Standard Format].
• Parameter
e: EPC encode
Type
Specify the parameter right after <IP0>.
The parameter cannot be omitted.
ESC
<1B>
16
Nil
When turning off the power
Valid range within item
Valid range between items
EPC encode type parameter
411
IP0
<49> <50> <30>
16 16 16
The set command is not maintained.
The set parameter becomes invalid.
The set parameter becomes invalid.
h [Standard format]
Use the three-character parameter
identifier after the declaration.
The memory area extended for each IC
chip manufacturer can be extended for
other than the standard Gen 2 tag.
Parameter
See under "Parameters".