SATO CL4NX Programming Reference Manual page 224

[Supplementary Explanation]
• This command supports UPC-A only. When barcode type is specified other than "H", command
error occurs.
• Recommended to specify [02] or [03] for the narrow bar width.
• Check digit (12th digit) for HRI data should be set the calculation result of modulus 10.
• Setting of Guard bar, HRI and Ratio is following.
Guard bar : Available
HRI : Available
Ratio : Fix
• When the parameter value exceeds the range, operation is not supported.
• If barcode with human readable text has errors, the human readable text is printed in a normal
font.
• All character barcode have the same height when printing UPC-A specifying <BD> and then
<font>. The first and the last character barcode have the same height to the guard bar when
printing UPC-A specifying <BL> and then <font>. When printing UPC-A specifying <BD> and
<font>, HRI can be printed under the first digit and the last digit because the height of the
first digit and the last digit of the barcode is low. When printing UPC-A specifying <BM> and
<font>, the height of the first digit and the last digit of the barcode is high, and the font interval is
narrower than previous case.
Guide bar
Character barcode
First digit
UPC-A specifying <D> + <font>
Guide bar
Character barcode
First digit
UPC-A specifying <BL> + <font>
Parent topic Barcode Command
Guide bar
Character barcode
Last digit
Guide bar
Character barcode
Last digit
222