SATO CL4NX Programming Reference Manual page 273

[Supplementary Explanation]
• If Parameter other than above is specified or print data do not match, printing is not performed.
• When specifying print format, secure more than 2 mm blank space in four sides of the
DataMatrix for read margin for the scanner.
• When print data is 7EH, specify "7EH, 7EH". Number of data will be "0002".
• When Auto setup (000) is applied for [Number of cell in one row] and [Number of cell lines] ,
square DataMatrix is printed.
• The number of addressable data at data part is depending on data format. Following chart
shows the number of addressable data (When the number of cell is set automatically or the
maximum number of cell is specified).
Data format
• It is likely that symbol cannot be read by reducing the size of cell, which depends on the
performance of scanner. In this case, it is required to specify the size of cell which is large
enough for reading symbol.
Data format
Numeric
Alphanumeric
Binary (00H to FFH)
271
Number of data
3116
2335
1556