[Esc+Al] Field Alignment - SATO CL4NX Programming Reference Manual

[ESC+AL] Field alignment

Hexadecimal code
Initial value
Valid range and term of
command
[Function]
The base reference point specified with print positioning commands <H>, <V> is equal to the
"Alignment position" of this command. The field's base reference points are changeable with
"Alignment position". The supported fields are all text fields, barcode, 2D barcode, graphics, ruled
lines and boxes etc.
[Format]
<AL>a
• Parameter
a Alignment position
1: Top left
2: Top center
3: Top right
4: Middle left
5: Middle center
6: Middle right
7: Bottom left
8: Bottom center
9: Bottom right
[Field and alignment positions (for font command)]
The number inside the circle indicate the value of parameter a, "Alignment position (the positions
specified with print positioning commands <H>, <V>".
BlogÁe
1
4
7
Field: The area that is rendered with one command
ESC
<1B>
16
a=1
When the power is OFF
Valid range within items
Valid range between items
2
5
8
For horizontal orientation
AL
<41> <4C>
16 16
The set parameter is not maintained.
The set parameter is valid until the next valid setting.
The set parameter becomes initial value at the next item
<A>.
1 2 3
3
6
9
5
4 6
7
8 9
For vertical orientation
66
Parameter
a