SATO CL4NX Programming Reference Manual page 575

[Sample of status reply 4] (format set to ASCII)
When there is not an RFID tag or when an RFID tag is bad.
Command
Status reply [STX]2,06[ETX]
Command
Status reply [STX]2,06[ETX]
Command
Status reply [STX]2,06[ETX]
[Supplemental explanation]
• This command cannot be used in combination with commands other than <A> and <Z>.
• Available with the following printer operation modes:
continuous, cutter (backfeed after print), and dispenser (backfeed after print).
Not available with tear-off, cutter (backfeed before print), dispenser (backfeed before print).
• Not available with RFID tag offset is set to a non-default value.
• Because this command cannot be received while printing it, information cannot be acquired in
"Sequential number" and "Print Quantity" piece is specified.
• After this command is transmitted, it will take about five seconds by the time all the sending
return status is sent back by the host. Tag information is not correctly sent back when the port
is cut before all the sending return status is sent back by the host, data other than the sending
return status format are sent back, and operate it, please after selecting data.
• Please do not transmit other commands and data until all the status of the defined size is
received by the host after transmitting this command.
• Refer to the following chart if you want to specify the alphabet "A" in ASCII/HEX data formats.
Data
Code
• For my-d tag, custom mode is read by default. However, in order to force read with ISO mode,
specify "AI" and "HI" as an option. "AI" stands for ASCII format and "HI" stands for HEX format
data reply.
• Only my-d tags can be specified for options "AI" and "HI". If you specify other than my-d, the
options will be identified as "AS" and "HX".
• If the printer is a low power consumption mode is enabled, until it wakes up will return a "NAK".
[DC2]PJ,H1,AS
Inlet type (RFID tag none/reading error)
[DC2]PJ,H1,H3,AS
Inlet type (RFID tag none/reading error)
[DC2]PJ,HA,AS
Inlet type (RFID tag none/reading error)
Mode ASCII
'A'
41H
573
HEX
"41"
34H,31H