[Supplementary Explanation]
•
Barcode character pitch is available for CODABAR (NW-7), CODE39, Industrial 2of5, Matrix
2of5.
To specify barcode character pitch, insert Character Pitch <P> right before Barcode type. When
<P> is omitted, character pitch will be as same as narrow space width and it is a multiple of
narrow bar width.
•
Example)
Command
<BT>
•
If there is no Registration of Bar Width Ratio <BT>, barcode based on pre-registered bar
width ratio of narrow and wide bars will be printed. Note that specification of <BT> is required
beforehand to print.
•
For print data for Barcode type, refer to Code table for each Barcode.
[Note]
•
If the value other than valid range is set, command error will occur and barcode will not be
printed.
•
Barcode will be printed even if the data exceed the printing area.
•
Increasing narrow bar width may exceed the print area and not be printed.
•
Scanner may not read the barcode with valid character pitch when Character Pitch <P> is
increased. Also, increasing the narrow bar width may cause the same type of problem. For
more information, refer to the documentation of your scanner.
•
For specifying the narrow bar width, consider the reading compatibility of scanner beforehand.
•
Adjust Print Speed <CS> or Print Darkness <#F> if there is a problem in barcode reading.
•
Matrix 2of5 is expressed as Coop2of5/NEC2of5.
•
When CODABAR (NW-7) and CODE39 is specified and Start/Stop character is not included in
it, Barcode is printed but Scanner cannot read it.
Ratio
Narrow
space width
3:5
3
<P>
specification
None
3
<P>0
3
<P>1
1
<P>2
2
<P>3
3
<P>4
4
194
Gap between characters
Narrow bar
Narrow bar
width is [1]
width is [2]
6
6
2
4
6
8