System Command; Esc+Cs Print Speed - SATO WS4 Series Programming Reference Manual

13. System Command

System
Available for
WS4 series

ESC+CS Print Speed

Print Speed
ESC
Hex code
<1B>
16
Default setting See table below
When printer is powered off
Persistence of
Validity in a job
the command
Validity after a job
[Function]
Specifies print speed.
[Format]
<CS>a
●Parameter
a [Print speed]
[Coding Example]
<A>
<CS>3
<Z>
[Note]
1. The setting by this command will not persist after powering off the printer. When the printer restarted, either the printer' default value,
or original values set by the command <PG> will be valid.
[Tips]
1. Invalid range being selected will result in a command error and the setting will not be changed.
2. The default values are available by the operation of the printer side.
[Parameter default value and valid range]
Model Default value
WS408DT/TT
WS412DT/TT
CS Parameter
<43> <53> a
16 16
Set parameter will not be retained
Retained until next valid setting
Retained until next valid setting
= see table below.
Parameter range
5 2, 3, 4, 5, 6
4 2, 3, 4
ESC+CS
Parameter: Printer speed
2 : 2 inch/sec (50mm/sec)
3 : 3 inch/sec (75mm/sec)
4 : 4 inch/sec (100mm/sec)
5 : 5 inch/sec (125mm/sec)
6 : 6 inch/sec (150mm/sec)
171