Using Input Channel Controls - Polycom SoundStructure C16 Design Manual

For more information on the processing available for the Conference Link2 channels, see
Conference Link2.
level_pre and level_post Processing for Conference Link Channels
Codec Program
Audio In
Codec
Video Call In
Inputs from
Polycom Video
Codec over CLINK2
Codec
Video Call In
Codec
UI Audio In

Using Input Channel Controls

This section discusses the input controls in the order the channels display on the Channels page. The input
channel settings are shown in the following figure in both a collapsed view and with the different areas
expanded to show the additional controls.
You can also set any setting for a virtual channel can by adjusting the setting on a virtual channel group. By
using virtual channel groups, the system can be setup very quickly because the parameters propagate to
all the underlying virtual channels.
The input channel controls are expanded to show less frequently used controls such as phantom power,
trim, delay compensation, and the selection of the different ungated signal types. See
Polycom SoundStructure Product
Polycom, Inc.
Dynamics Parametric
Processing Equalization
Dynamics Parametric
Processing Equalization
level_pre
Familyfor more information about the ungated/recording signal types and
Mute
Fader Delay
Mute
Fader Delay
Connecting Over
Matrix
level_post
Introducing the
97