Polycom Ir Remote Channel Id; Ir Receiver Connector - Polycom SoundStructure C16 Design Manual

Hide thumbs Also See for SoundStructure C16:

Table of Contents

Events Created for Polycom IR Remote

IR Remote Phone *

IR Remote Phone #

IR Remote Phone Disconnect

IR Remote Phone Connect

IR Remote Mute

IR Remote Preset Press

The automatically generated events may be customized to suit a particular application and additional events

for the other key presses on the Polycom IR remote may be added by using the Add Events feature.

Polycom IR Remote Channel ID

SoundStructure Studio creates projects assuming the Polycom IR remote has the default Channel ID of 3.

Changing the default value from 3 to an alternative value may be done on the logic page by adjusting the

knob of the channel ID from 0 to 15.

Polycom IR Remote Channel ID

To use a Polycom IR remote transmitter, the SoundStructure system requires an IR receiver. Each

SoundStructure device includes an IR receiver interface port that can be used with IR receivers from

Xantech including models 780-80, 780-90, 480-00, 480-80, and 490-00. The IR receiver should be

connected to the SoundStructure device using the pin out shown in the following figure.

Polycom, Inc.

Dials the digit "*"

Dials the digit "#"

Hangs up the phone

Takes the phone offhook

Toggles the state of clink_mute which is used to mute all

Runs the preset "Polycom IR Remote Preset"