Setting Output Signals - Polycom SoundStructure C16 Design Manual

Hide thumbs Also See for SoundStructure C16:

Table of Contents

The controls for sine and sine sweep allow for additional parameters to be set, as shown in the following

Sine and Sweep User Controls in SoundStructure Studio

Setting Output Signals

This section describes the user interface for setting output signals. Every output signal has the processing

capabilities described in the following section.

All output signals have signal meters, as shown in the following figure. To enable the signal meters, select

Tools > Options. Choose the meters entry and select Enable Meters. Meters may also be enabled by right

clicking on the meter indicator on the lower right portion of the main SoundStructure Studio window. This

figure shows the level_post meter for an output and the SoundStructure Studio user control for the

meters and gain control. As presented in

Installing SoundStructure

Devices, the level slider affects the

analog signal level on the output of the digital to analog converter. Positive gain is added in the digital

Polycom, Inc.