Soundstructure System Requirements; Upgrading A Project To The Soundstructure Voip Interface - Polycom SoundStructure C16 Design Manual

● Supporting 24 call appearances means that 24 remote participants can be dialed into the
SoundStructure VoIP Interface and one remote participant or a conference of two remote participants
can be active and that mix of remote participants sent to the SoundStructure system. All other call
appearances that are not part of the call sent to the SoundStructure VoIP Interface would be on hold.
● The SoundStructure VoIP Interface supports calling more than one remote participant in the same
conference. This means that, if you are using a TEL2 card to support dialing two remote parties into
the same call, you can also do this with the SoundStructure VoIP Interface. See the example of calling
two remote parties:
● Two independent calls are not supported on the SoundStructure VoIP Interface. In other words, if you
are using a TEL2 card to support two independent telephone calls, such as for a split/combine room
operation, you will need two SoundStructure VoIP Interfaces.

SoundStructure System Requirements

To use the SoundStructure VoIP Interface, the following versions of software are required. To get the latest
software versions, please visit
SoundStructure system.
SoundStructure Firmware version 1.5
This firmware version is fully compatible with configuration files created with earlier versions of
SoundStructure Studio.
SoundStructure Studio version 1.7
This studio version is fully compatible with configuration files created with earlier versions of SoundStructure
Studio. Once a configuration file has been created with version 1.7.0 it may not be backwardly-compatible
with earlier versions.
SoundStructure VoIP Interface Firmware version 4.0.1
Support for the SoundStructure VoIP Interface requires version 4.0.1 or later of the Polycom UC Software
for the SoundStructure VoIP Interface. By default, the SoundStructure VoIP Interface product ships with
version 4.0.1 or later installed.
Upgrading a Project to the SoundStructure VoIP
Interface
An existing SoundStructure project with PSTN interface may be upgraded to the SoundStructure VoIP
Interface with the Upgrade Plug-in Card tool. This new tool has been designed to upgrade a SoundStructure
project from one set of telephony plug-in cards to a different set of plug-in cards. This section shows you
how to use the Upgrade Plug-in Card Tool with an example that upgrades a SoundStructure project from a
SoundStructure TEL1 card to the SoundStructure VoIP Interface.
For a summary of the all the steps required to update an install from a SoundStructure TEL1 to a
SoundStructure VoIP Interface, see the
Support.
Polycom, Inc.
Dialing Two Calls on the Same
Polycom Support
SoundStructure VoIP Interface Quick Upgrade Guide
Line.
and download the versions of software for your
on Polycom
308