Wiring Information - Polycom SoundStructure C16 Design Manual

Zone 3 and Zone 4 microphones will have Zone 3 and Zone 4 amplifiers selected as shown in the next
figure. This figure shows the Zone 1 microphones.
Zone 1 Microphones
The references for the lectern microphone can also be set to the Zone 1 and Zone 6 amplifiers. The wireless
microphone reference should be set to the remote audio, the program audio, and the reinforced audio. This
can be done easily by setting the references for the wireless microphones to the Zone 2 and Zone 5
amplifiers.

Wiring Information

The system should be wired according to the information found in the wiring page and shown in the following
figure. To wire the system with virtual channels on other physical inputs or outputs, simply drag the channels
to their desired locations and then wire the system according to the modified wiring information.
In this example, two C12 devices were required to implement the design. The two devices are linked with
the OBAM interface and each device is wired as shown in the following figure.
Polycom, Inc. 486