Polycom SoundStructure C16 Design Manual page 127

Hide thumbs Also See for SoundStructure C16:

Table of Contents

The user control of the signal generator is shown in the following figure. The type of noise is selected from

the Type pull-down control.

Signal Generator User Controls in SoundStructure Studio

To use the signal generator, unmute the crosspoint at the signal generator to the desired outputs. Typically

the signal generator is routed to loudspeakers as part of the setup process (see

Installing SoundStructure

Devices) to ensure loudspeakers are active and to adjust the loudspeaker levels in the room.

Polycom, Inc.

Troubleshooting