Processing The Polycom Video Codec Soundstructure Signals - Polycom SoundStructure C16 Design Manual

Processing The Polycom Video Codec SoundStructure Signals

Each of the signals that the Polycom Video Codec system sends to the SoundStructure device have
processing that can be applied as shown in the following figure. This processing is configured through the
SoundStructure Studio software.
Processing Signals for Polycom Video Codec
Codec Program
Video Call In
Inputs from
Polycom Video
Codec over CLINK2
Video Call In
UI Audio In
The Codec Program Audio In and Codec Video Call In channels have dynamics processing, parametric
equalization, an input fader, input delay, and mute control available for their input processing. In addition
there are signal level meters that can be displayed for these channels.
The Codec Voice Call In and Codec UI Audio In channels are routed directly to the SoundStructure matrix
and do not have dedicated SoundStructure input processing or signal level metering. If processing or
metering is desired on these signals before the signals are used in the matrix, these signals may be routed
to the SoundStructure submixes where dynamics processing, parametric equalization, fader, delay mute
control, and signal level meters are available. The outputs from the submixes may then be used as inputs
to the matrix. As with other virtual channels, the submix signals have virtual channel names and are
controlled in the same fashion as any other virtual channel within a SoundStructure system.
Polycom, Inc.
Dynamics
Audio In
Processing
Codec
Dynamics
Processing
Codec
Codec
Parametric
Fader
Equalization
Parametric
Fader
Equalization
Mute
Delay
Mute
Delay
Matrix
156