Detecting Clink2 Devices; Viewing Digital Microphone Array Example - Polycom SoundStructure C16 Design Manual

Hide thumbs Also See for SoundStructure C16:

Table of Contents

Note: Microphone Firmware Compatibility

To make sure the firmware on the microphone arrays is compatible with the

SoundStructure device, during the installation process plug the microphone chain

(up to four microphones may be cascaded during this process) into the right CLink2

port of SoundStructure for 30 seconds to ensure the firmware is updated to the

version required for SoundStructure operation.

This process only needs to be done once, even if the microphones ultimately are

connected directly into the

Detecting CLink2 Devices

When connected to a SoundStructure device, the wiring page shows the status of the number and type of

CLink2 devices. This information is shown in the following figure where two table mics and one Polycom

Video Codec were discovered. To have this information automatically updated as devices are connected

over CLink2, select the poll device information check box on the top of the wiring page.

As an example of using the digital microphone arrays, consider a design that uses two ceiling microphone

arrays, one wireless analog microphone, a stereo program audio source, a Polycom Video Codec

conferencing system, a telephone line, and a stereo amplifier.

Polycom, Inc.

and not the SoundStructure device.

Status and Type of Conference Link2 Devices on the Wiring Page