Polycom SoundStructure C16 Design Manual page 688

Ethernet Authentication
Argument Argument value
Channel Type Global System
Value Type List
Read/Write Mode Read/Write
Values open : Unauthenticated connections on port 52774 (default)
auth : Authenticated connections on port 52775
Event Source No
Description
This parameter selects the port for Ethernet control connections. If set to open, then connections are
accepted on port 52774 and do not require authentication. If it is set to auth, then connections are accepted
on port 52775 and authentication is required.
Ethernet Settings—eth_settings
Argument Argument value
Channel Type Device-Specific System
Value Type String
Read/Write Mode Read/Write
System Limits Max String Length: 256
Default mode='dhcp'
Event Source No
Description
This parameter gets or sets the Ethernet settings. When this parameter is set, the Ethernet interface is
automatically restarted with the new settings.
The format of the string is a comma-separated list of name/value pairs with the name and value separated
by an equals character, and the value enclosed in single quotes.
The mode attribute is always required. It must be either dhcp or static.
The addr, dns, gw, and nm attributes are required when mode is static and ignored (not required) when mode
is dhcp. They are always returned in the acknowledgment. For the dhcp case, they specify the values obtained from
the DHCP server.
The addr attribute specifies the IP address of the interface. The dns attribute specifies the domain name server(s).
A single server or multiple servers (separated by spaces) may be specified. The gw attribute specifies the gateway. The
nm parameter specifies the netmask.
Polycom, Inc.
Mode—eth_auth_mode
688