Positioning A Polycom Video Codec Camera Example - Polycom SoundStructure C16 Design Manual

Hide thumbs Also See for SoundStructure C16:

Table of Contents

Step 2: Create the event

Once the logic pin has been defined, an event mapping the microphone gating status to the logic output can

In this example, when the Table Mic gates on the automixer, the logic output will be set to 1 and when the

microphone gates off, the logic output will be set to 0.

When the microphone gates on, the SoundStructure system will send the acknowledgment:

val digital_gpio_state "Mic 1 Gate" 1

when the microphone gates off, the following acknowledgment will be sent:

val digital_gpio_state "Mic 1 Gate" 0

A control system can use the acknowledgments from the logic output pins to indicate on a touch panel that

the particular microphone is gated on or off. If there are multiple microphones in a system, each microphone

can have events that connect the microphone gating status to a different logic output pin.

Positioning A Polycom Video Codec Camera Example

In this example, camera gating information will be used to send a command to a video codec over the serial

interface of SoundStructure.

Polycom, Inc.