Upgrading The Firmware In The Soundstructure System - Polycom SoundStructure C16 Design Manual

At this point, you have created an offline project that includes the SoundStructure VoIP Interface.
Configuration of the SoundStructure VoIP Interface settings will be described in
SoundStructure VoIP Interface.
If you have completed your customization, you can now upload the configuration file to a SoundStructure
C12 system that has the SoundStructure VoIP Interface installed and continue with configuring the
SoundStructure VoIP Interface settings once connected online.

Upgrading the Firmware in the SoundStructure System

Before loading a project with a SoundStructure VoIP Interface to a SoundStructure system, ensure that you
are running SoundStructure device firmware 1.5.0 or later.
To upgrade the firmware in the SoundStructure system, use the following steps.
1 Select the Connect menu option in SoundStructure Studio and select the Search for Devices
option and select the desired system from the list of discovered systems. Systems will be
discovered if they are on the same subnet as your computer. If your system is not discovered, you
can manually enter the IP address of the system or choose a system from the address book. You
may also connect to your system over RS-232 if you don't have an IP connection.
2 Once the system is identified, select the Get configuration from devices option and select
Connect as shown next.
Polycom, Inc.
If you upload a configuration that requires a SoundStructure VoIP Interface to a
SoundStructure system that does not have a SoundStructure VoIP Interface
installed, the Upgrade Plug-in Card tool will be automatically run to allow you to
modify the project to match the installed hardware.
Configuring the
322