Polycom SoundStructure C16 Design Manual page 328

4 If the login to the provisioning server is successful, the appropriate bootROM and software files will
be loaded if the files on the server are newer than the existing bootROM and software versions in
the flash of the interface, and the appropriate configuration parameters will be loaded from the
provisioning server.
5 If the interface is provisioned, it will use the SIP server registration information and appropriate
credentials found from the device configuration parameters and register one or more lines with the
call management server.
6 If the system SIP lines register properly, the interface will receive its line extension information and
calls may be initiated.
Configuring the SoundStructure VoIP Interface Network Settings via the Web
Configuration Utility
You can manually configure the SoundStructure VoIP Interface's IP address and provisioning settings with
SoundStructure Studio or with the Web Configuration Utility.
To find the IP address of the SoundStructure VoIP Interface, connect to the online SoundStructure device
with SoundStructure Studio and navigate to the Wiring page. The IP address of the SoundStructure VoIP
Interface is found in the lower right-hand portion of the display as shown in the following figure.
SoundStructure VoIP Interface IP Address
In this example, the IP address of the SoundStructure VoIP Interface is 172.22.3.159.
If the network address is not listed, then the SoundStructure VoIP Interface did not receive an IP address
from a DHCP server and either its network cable must be installed or its IP address must be configured
manually through SoundStructure Studio.
Polycom, Inc. 328