Processing Output Dynamics; Processing Equalization - Polycom SoundStructure C16 Design Manual

The minimum AGC value specifies the maximum amount of attenuation the AGC can apply to attenuate the
input signal as the AGC tries to reach the SoundStructure nominal signal level.

Processing Output Dynamics

The output dynamics processing available on the outputs is the same as the input dynamics processing
described in the Using Dynamics Processors

Processing Equalization

The equalization processing that is available for both the telephone input and output signals, as shown in
the following figure, consists of the following dedicated filters:
● Low Pass
● High Pass
● Low Shelf
● High Shelf
● 10 parametric equalizers
The telephone input and output can be configured to have different equalization.
Dedicated Equalization Filters
To enable a filter, click the check box next to the filter. This makes the filter the active filter and allows the
parameters to be changed as shown next.
The cut off frequency can be adjusted between 0 Hz and 20,000 Hz, the order can be adjusted from 2
th
8 , and either a Butterworth or Linkwitz-Riley filter may be selected.
Polycom, Inc.
section of this chapter.
nd
to
145