Creating Soundstructure Events Best Practices - Polycom SoundStructure C16 Design Manual

This example assumes that serial port on SoundStructure has been placed in broadcast mode. This may
be configured from the wiring page as shown in the following figure.
This example shows that the ser_send command is used to send the serial command from the serial port
on the SoundStructure with device ID 1. The command being sent is preset near go 1. The "\r" at the end
of the command name represents a carriage return.
If an RS232 port is in the broadcast mode then that serial port cannot be used for controlling the
SoundStructure system from an external control system or SoundStructure Studio.

Creating SoundStructure Events Best Practices

When creating SoundStructure events, the following recommendations will make it easier to use events.
1 Define logic inputs and outputs before trying to use logic inputs or outputs with events.
Polycom, Inc. 268