Running Presets - Polycom SoundStructure C16 Design Manual

Reordering Entries In A Partial Preset
The order of execution of the commands in a partial preset may be adjusted by changing the order of the
lines in the partial preset. To move a line, select the line and select the up or down arrow as shown in the
following figure.
After entries have been moved, select Save Selected to save the new execution order.
Saving Presets

Running Presets

Both full and partial presets may be executed when in SoundStructure Studio by left clicking the preset to
execute and then clicking Run Preset.
A control system would execute the preset with the command action run as in the following example:
run "Power-On"
In version 1.5 or later firmware, once a preset run command has been executed, the SoundStructure system
immediately responds with an acknowledgment as shown below to indicate that it is running a preset.
run "Power-On"
Full Presets
When a full preset is executed all the outputs of the system are muted during the execution of the preset
and then unmuted after the full preset finishes executing.
No command acknowledgments are generated when a full preset is executed. If there are parameters that
a control system needs to know the value of, these parameters should be queried after the execution of the
preset.
Once the full preset has finished running, a 'ran' command acknowledgment is generated as shown next.
ran "Power-On"
Polycom, Inc. 231