Creating Events With Soundstructure Studio; Adding New Events; Enable And Disable Events - Polycom SoundStructure C16 Design Manual

Creating Events With SoundStructure Studio

SoundStructure Studio allows the A/V designer to create events with the Add Event button on the Events
page. As we'll see shortly there are a number of events that are created automatically.

Adding New Events

Clicking the add event button shows a user control that allows the designer to create an event name and
then the source, trigger, and action. Similar to channel names, event names must be unique and are case
sensitive. We recommend you use a name that makes sense to you.
To create an event, select the source, the trigger, and the type of action and select Add.
Adding an Event
Once the events are created, the events page shows the entire list of events as shown in the following figure.
The events page may be sorted by any of the column headings including the Event Name, Source,
Parameter, Trigger, and Action.
Events may be edited by double clicking on an event on the Events page. Once completed, click Save to
save the event or cancel to not save the event.

Enable And Disable Events

Events may be enabled or disabled by checking or unchecking, respectively, the box to the left of the Event
name. Disabling events is intended to simplify troubleshooting a system that may have many events. Once
events are enabled, the trigger is re-evaluated for all map actions and the resulting action executed.
The Enable All and Disable All buttons enable or disable all events that have been defined.
Polycom, Inc. 236