SoundStructure Studio version 1.8
This studio version is fully compatible with configuration files created with earlier versions of SoundStructure
Studio.
Configuration files created with SoundStructure Studio 1.8 are not compatible with older versions of
SoundStructure Studio because there are new parameters defined to support authentication.
Enabling Authentication on a SoundStructure System
To use the authentication features you must update the SoundStructure system firmware to version 1.6 or
newer and connect to the system using SoundStructure Studio version 1.8 or newer. Instructions for
updating firmware are provided in
Once connected to the SoundStructure System, follow these steps.
1 Navigate to the system page by clicking on the system name, SoundStructure System, as shown
in the following figure.
2 Change the Authentication mode from Open to Authenticated.
Polycom, Inc.
Installing SoundStructure
Devices.
391