Creating A New Project - Polycom SoundStructure C16 Design Manual

Design Guide for Polycom SoundStructure Studio C16, C12, C8, and SR12 SoundStructure Studio 1.9.0
the case in this example because an entire SoundStructure device was added, the left pane is empty as
shown in the following figure.
Figure: New Channels Fitted into a New System
The result of the Edit Devices operation is a new configuration file that can be edited. The original device
configuration file remains unchanged. Once the device(s) have been added or changed, use the 'Edit
Channels' button to add more inputs and outputs to the system. Configure the settings for the new channels
(AEC reference, equalization, etc.) and then save the settings to a preset and then save the new
configuration file to disk.
Make sure the inputs and outputs of the system are physically wired according to how the new devices are
configured on Wiring page.

Creating a New Project

A new SoundStructure Studio project may be created for a multi-device system as easily as creating projects
for a single SoundStructure device. The steps required to create a file and upload to a collection of
SoundStructure devices are listed below.
1 Create a new project using SoundStructure Studio 1.2 or higher by selecting the desired inputs to
and outputs from the system in steps 1 and 2 of the design process.
Polycom, Inc. 187