Pairing The Polycom Touch Control With Soundstructure - Polycom SoundStructure C16 Design Manual

Pairing the Polycom Touch Control with
SoundStructure
Preparing the Polycom Touch Control Device:
1 Connect the Ethernet cable to the underside of the Polycom Touch Control device. The Polycom
Touch Control, by default, expects to receive an IP address from a DHCP server on the network. To
set a static IP address on the Polycom Touch Controller, see Configuring the Polycom Touch Control
LAN Properties.
2 To use the stand, route the Ethernet cables through the opening in the stand. Then attach the stand
to the Polycom Touch Control device by tightening the mounting screw with a screwdriver.
3 Plug the Ethernet cable into the wall Ethernet outlet.
Polycom, Inc. 286