Validating A Soundstructure Voip Interface Installation - Polycom SoundStructure C16 Design Manual

2 Click Continue when prompted.
A confirmation explaining that the server has been cleared. displays

Validating a SoundStructure VoIP Interface Installation

Once you have completed your SoundStructure configuration file, have uploaded the configuration file to
the SoundStructure system, and configured the SoundStructure VoIP Interface, you can validate your
installation with the following steps:
1 Confirm Version 1.7.0 or newer of SoundStructure Studio is used.
2 Confirm Version 1.5.0 or newer SoundStructure firmware is used.
3 Confirm a SoundStructure VoIP Interface channel is defined in the project.
4 Confirm the VoIP Status on Wiring page is 'ok'.
5 Confirm the SoundStructure VoIP Interface has a valid IP address.
6 Confirm there is a valid network route to the SoundStructure VoIP Interface.
7 Confirm the line is registered - or dial a SIP URL call to confirm the SoundStructure VoIP Interface
card has been installed properly except for line registration settings.
8 Confirm a call can be dialed using the registered line.
These steps are described in more detail in the following sections.
Version 1.7.0 or Newer of SoundStructure Studio Used
Version 1.7.0 SoundStructure Studio software is required for connecting to a SoundStructure system that
has firmware version 1.5.0 or newer and has a SoundStructure VoIP Interface card installed.
Polycom, Inc. 364