Polycom SoundStructure C16 Design Manual page 380

SoundStructure VoIP Interface API Commands
voip_call_appearance_info
voip_call_appearance_line
voip_call_appearance_state
voip_cancel
voip_conference
voip_dhcp_boot_serv
voip_dhcp_boot_serv_opt
voip_dhcp_boot_serv_type
voip_dhcp_option_60_type
voip_dial_mode
voip_dnd
voip_eth_settings
voip_eth_vlan_id
voip_factory_reset
voip_forward
voip_hold
voip_join
voip_line
voip_line_label
voip_line_state
1
voip_loc_city
voip_loc_company_name
Polycom, Inc.
Reports textual caller-id information for the specified call appearance.
Reports the line number associated with the specified call appearance.
Reports the state of the specified call appearance. Examples states
include 'connected', 'ringback', 'disconnected', and others.
Used to cancel a transfer or a conference.
Used to start a conference call.
Controls the boot server option for the plug-in card.
When voip_dhcp_boot_serv is set to custom, this parameter specifies
the DHCP option number in which the plug-in card will look for the boot
server.
When voip_dhcp_boot_serv is set to custom, this parameter specifies
the type of the DHCP option in which the plug-in card will look for the
boot server.
Specifies the format for the vendor identifying information used with a
DHCP server when DHCP option 60 is enabled.
Selects between number dialing and SIP URL dialing.
Enables or disables the Do Not Disturb mode on all lines.
Sets or gets the Ethernet settings for the plug-in card.
Sets or gets the VLAN ID for the plug-in card. A value of -1 corresponds
to no vlan id.
Resets the plug-in card to its factory state.
Used to forward a call.
Places the current call on hold.
Creates a conference from two calls.
Selects a line. This is similar to pressing a line key on a desktop phone.
Reports the label for the specified line.
Reports the state for the specified line, e.g., registered, not registered,
active, conference, hold, etc.
Displays the city field when the Lync Server is configured with
location information. Corresponds with the
Polycom UC software parameter.
Displays the company name field when the Lync Server is
1
configured with location information. Corresponds with the
loc.Info.x.NAM
Polycom UC software parameter.
loc.Info.x.A3
380