Controlling The Soundstructure System - Polycom SoundStructure C16 Design Manual

Design Guide for Polycom SoundStructure Studio C16, C12, C8, and SR12 SoundStructure Studio 1.9.0
If the target equipment does not support all the inputs and outputs that the project requires as shown in the
following figure, then the project must either be scaled back or the number or type of target devices
increased.
Figure: Required Inputs and Outputs for Target Equipment
To add more devices, follow the steps outlined earlier in this chapter in the Expanding or Contracting an
Existing Project section. If the size of the system is reduced, channels may need to be removed as
described previously.

Controlling the SoundStructure System

Only one control port (RS-232 or Ethernet) is required to control a collection of SoundStructure systems. If
multiple SoundStructure devices within a SoundStructure system are connected to the local network, as
shown in the following figure the IP address of the system is the address of the master or, if the master
doesn't have an IP connection, the system closest to the master that does have an IP connection. In the
Polycom, Inc. 193