Expanding Or Contracting An Existing Project - Polycom SoundStructure C16 Design Manual

Hide thumbs Also See for SoundStructure C16:

Table of Contents

Design Guide for Polycom SoundStructure Studio C16, C12, C8, and SR12

Expanding or Contracting an Existing Project

A configuration file for a single device may be expanded to support additional SoundStructure devices or a

configuration file for multiple devices may be contracted to operate on fewer SoundStructure devices by

opening the source configuration file offline, navigating to the Wiring page, and using the Edit Devices

button as shown in the following figure. The Edit Devices button is not active when connected online to a

SoundStructure system.

Edit Devices on the Wiring Page

The Edit Devices button brings up Convert Projects Device Wizard, a tool for changing devices used in a

SoundStructure project. There are two steps to the Convert Projects wizard - a step for selecting the devices

and telephony options, and, when downsizing, a step for removing channels. The following figure shows

Step 1 in the Convert Projects Devices Wizard where a C12 was added to the system. To add equipment,

Polycom, Inc.

Note: Edit Devices Only Available When Working Offline

The 'Edit Devices' button is only active when working offline. Once connected to a

SoundStructure system, the 'Edit Devices' button is disabled.

SoundStructure Studio 1.9.0