Polycom SoundStructure C16 Design Manual page 667

Description
When the signal generator's sig_gen_type is set to sweep, the parameter sets the frequency (in Hz) at which
the sweep generator stops. The direction of the frequency sweep will be up or down depending on whether
the sig_gen_sweep_start parameter is higher or lower than this parameter.
Signal Generator Sweep
Argument Argument value
Channel Type Virtual Channel
Value Type Integer
Read/Write Mode Read/Write
Phys Chans Signal Generator
Virt Chans Mono
System Limits Minimum: 10, Maximum: 60000
Default 10000
User Limits No
Supported
Event Source No
Description
When the signal generator's sig_gen_type is set to sweep, this parameter sets the duration (in milliseconds)
that the sweep generator takes to sweep from its start frequency to its stop frequency.
Polycom, Inc.
Time—sig_gen_sweep_time
667