Polycom SoundStructure C16 Design Manual page 206

To upload a configuration file to the SoundStructure devices, first open the SoundStructure Studio design
file and then select Connect > Search for Devices as shown in the following figure.
Searcing for Devices
This selection makes the Connect to Devices window display as shown in the next figure. There are two
ways to connect to the SoundStructure device: through the RS-232 and through the network interface.
Select the check box next to the interface to use for the upload or download.
When the check box next to the Network interface is selected, SoundStructure Studio queries which devices
are on the network. All devices on the same subnet as the Ethernet interface are displayed by default.
The SoundStructure system names that are found are shown with their System Name (see Managing
SoundStructure Systems for information on how to set the system name), IP address or serial port, and
MAC address. The MAC address may be found by looking inside the front panel door on the SoundStructure
device.
Polycom, Inc. 206