Polycom SoundStructure C16 Design Manual page 188

Design Guide for Polycom SoundStructure Studio C16, C12, C8, and SR12
2 On step 3 of the design process, either select the default equipment (if it matches your target
devices) or manually change the equipment to match the equipment that you already have. Add the
equipment in the order that you have the devices OBAM linked together. In the previous example
this would mean adding first a C16, then a C12, and finally a C8.
3 On Step 4 of the design process, select Offline configuration.
4 Once the project has been completed, confirm the actual wiring of the system to ensure the physical
input and output wiring matches the wiring page.
Viewing Physical Channels on the Wiring Page
As described in Introducing SoundStructure Design
linked together, the numbering of the physical channels is sequential across the devices. The wiring page
shows the wiring information including both the local input/output numbering and the global input/output
numbering as shown in the following figure where the local input/output numbering on the C12 ranges from
1-12 while the global numbering ranges from 17-28 because the C16, as the first device reserves the
numbering 1-16.
Polycom, Inc.
Concepts, when multiple SoundStructure devices are
SoundStructure Studio 1.9.0
188