Polycom SoundStructure C16 Design Manual page 297

Hide thumbs Also See for SoundStructure C16:

Table of Contents

Adjusting the volume on the Polycom Touch Control adjusts the value of the fader parameter of the channel

"Amplifier". This event may be customized to support different channels or different channel names. "Ampli-

fier" is the name used by default.

Adjusting Polycom Touch Control Volume and Fader

By default, SoundStructure Studio automatically sets the fader min of the "Amplifier" channel to -31 and the

fader max to +20. This maps the volume range of the Polycom Touch Control slider from 0 to 51 to the fader

range of -31dB to +20dB as shown in the following figure.

Polycom Touch Control Volume and Fader Controls

If a different fader min and max range is desired, new fader min and max values may be set by clicking and

dragging the fader min and max controls on the Channels page within SoundStructure Studio and then

saving the settings into the project.

_SST to Polycom Video Codec Volume

The '_SST To Polycom Video Codec Volume' event is the companion to the '_Polycom Codec to SST Vol-

ume' event and maps the fader parameter of the "Amplifier" channel to the volume level on the Polycom

Touch Control. Adjusting the volume of the fader of the "Amplifier" channel through some other control

Polycom, Inc.

_Polycom Video Codec to SST volume

Maps Volume to "Amplifier" fader

set fader "Amplifier" -31

set fader "Amplifier" 20

SoundStructure

Troubleshooting