Polycom SoundStructure C16 Design Manual page 269

2 Confirm the wiring of the defined logic inputs and outputs matches the physical wiring to the DB25
connectors on SoundStructure devices. If necessary move logic pins definitions on the wiring page
to match the physical wiring.
Note: Moving Logic Pins on the Wiring Page
If logic pins are moved on the wiring page, save the project file to ensure the
settings are stored permanently into the SoundStructure device.
3 Double check the source, trigger, and action to ensure the event does what you desire.
4 Test logic inputs and events when working offline with SoundStructure Studio.
Logic Pins Forced to Open or Close
Logic input pins may be forced to closed or open with
set digital_gpio_state "logic pin" 0 command to close a switch or
set digital_gpio_state "logic pin" 1 to open a switch. The name "logic
pin" should be replaced by the name of the pin you are testing.
5 Use the event enable/disable option if it is necessary to isolate and test individual events
6 Select event names that are meaningful to make it easier to interpret the event list
Polycom, Inc. 269