Configuring The Signal Gains - Polycom SoundStructure C16 Design Manual

Hide thumbs Also See for SoundStructure C16:

Table of Contents

Updating Firmware

Click on Update to begin the firmware transfer to the device. A window displays to confirm that the firmware

file should be sent to the selected device. Select Yes to continue the firmware transfer or No to not update

Updating Firmware Confirmation

Once the firmware transfer begins, the progress is updated with a display as shown in the following figure.

Firmware Update Progress

Upon completion of a successful firmware transfer, the SoundStructure device reboots and SoundStructure

Studio presents the Connect to Devices window to allow SoundStructure Studio to re-connect to the device.

Wait for the device to finish re-booting (front-panel green light stops flashing) and connect to the device.

If a firmware transfer is not completed successfully - perhaps because power was lost to the device or the

transfer cable was mistakenly pulled out - the SoundStructure system reverts back to the firmware that was

in the device prior to the firmware update process was initiated.

Configuring The Signal Gains

Once the SoundStructure device settings are synchronized with SoundStructure Studio, either by uploading

or downloading a configuration file, the next step is to ensure the input signals have the proper analog gain

to get to the 0 dBu nominal signal level of the SoundStructure devices.

Polycom, Inc.