The machine's DC power supply PCB and those of its accessories are equipped with protective functions against excess current and voltage, which will automati-

cally cut off the output voltage in response to an error power condition (caused, for example, by a short-circuit on a load).

If any of these protective mechanism has gone on, turn off the main power switch of the printer unit, and remove the cause of activation; then, leave the machine

alone for about 3 min, and turn its power back on to reset it.

10.4.3 Backup Battery

10.4.3.1 Backup Battery

imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+

The SRAM PCB and the DC controller PCB of the machine's main controller PCB are equipped with a lithium battery (1 pc. each) serving as a backup source of

power in the event of a power shortage or when the power plug is removed.

SRAM PCB

DC controller PCB

Life

Replacement

LISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.

DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

Do not use a battery which is not of a type specifically indicated (same name, or equivalent).

Dispose of any used battery according to the instructions of its manufacturer.

10.4.4 Energy-Saving Function

10.4.4.1 Overview

imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+

1. Standby Mode

The machine is in operation or is ready to start operation, with all its loads supplied with power.

2. Power Save Mode

The machine deceases the control temperature while the fixing assembly is in a standby state according to the selected power save rating (variable through 'change

power save mode' in user mode; default: -10%), thus decreasing the power consumption.

Conditions Initiating a Shift from Standby Mode (standby -> power save)

10-8

Main power SW

OFF

Deep sleep

OFF