Port Setup - ZyXEL Communications XS1930-12HP User Manual

Table 29 Basic Setting > IP Setup > IP Configuration (continued)
LABEL
Type
Delete
Cancel

8.7 Port Setup

Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the navigation panel
to display the configuration screen.
Figure 63 Basic Setting > Port Setup
The following table describes the labels in this screen.
Table 30 Basic Setting > Port Setup
LABEL
Port
*
Active
Chapter 8 Basic Setting
DESCRIPTION
This field displays the type of IP address status.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Click Cancel to clear the check boxes.
DESCRIPTION
This is the port index number. * means all ports.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable a port. The factory default for all ports is enabled. A port must be
enabled for data transmission to occur.
XS1930 Series User's Guide
89