Port Setup; Chapter 34 Port Setup - ZyXEL Communications GS1920v2 Series User Manual

34.1 Port Setup

Use this screen to configure Switch port settings. Click PORT > Port Setup > Port Setup in the navigation
panel to display the configuration screen.
Figure 140 PORT > Port Setup > Port Setup
The following table describes the labels in this screen.
Table 100 PORT > Port Setup > Port Setup
LABEL
Port
*
Active
Name

Chapter 34 Port Setup

DESCRIPTION
This is the port index number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable a port. The factory default for all ports is enabled. A port must be
enabled for data transmission to occur.
Enter a descriptive name that identifies this port. You can enter up to 128 printable ASCII
characters except [ ? ], [ | ], [ ' ] or [ " ].
Note: Due to space limitation, the port name may be truncated in some Web
Configurator screens.
GS1920v2 Series User's Guide
C
H A P T E R

Port Setup

207
34