Feature And Hardware Compatibility; Isdn Pri Configuration Prerequisites; Isdn Configuration Task List - HP MSR Router Series Wan Access Configuration Manual

Figure 38 Data ISDN application scenario
Figure 39 Voice ISDN application scenario

Feature and hardware compatibility

ISDN is supported only on the BS, E1, and T1 interface modules.

ISDN PRI configuration prerequisites

Before you can use a CE1/PRI or CT1/PRI interface to provide ISDN PRI services, you must use the pri-set
command to bundle timeslots into channel sets on the interface. For each PRI set, the system creates a
serial interface automatically. To configure ISDN settings for a PRI set, you must enter the view of this
serial interface.
For more information about timeslot bundling, see the WAN interface part in Interface Configuration
Guide.

ISDN configuration task list

This chapter describes only ISDN configurations on a BRI or PRI interface. For more information about
other BRI and PRI interface configurations, see Interface Configuration Guide.
To configure ISDN PRI or BRI, perform the following tasks:
Tasks at a glance
(Required.)
(Required.)
(Optional.)
Setting the ISDN switch type on an ISDN interface
Setting the ISDN functionality of an ISDN interface
Configuring SPID parameters for the NI switch type
Remarks
The switch type must be the same as the
service provider switch type.
When you connect two ISDN devices, you
must place one end at the user side and
the other end at the network side.
This task is available only on BRI
interfaces.
111