Configuring Vofr Packets To Carry Sequence Number; Displaying And Maintaining Vofr - HP FlexNetwork MSR Series Configuration Manual

Step
2. Enter voice view.
3. Configure the trunk wait
timer length in the FRF.11
trunk mode.
NOTE:
All FRF.11 trunks use the same trunk wait timer length.

Configuring VoFR packets to carry sequence number

For details, see

Displaying and maintaining VoFR

Task
Display the utilization statistics of
a voice channel.
VoFR configuration examples
This section provides VoFR configuration examples.
Huawei-compatible VoFR
Network requirements
As shown in
with Telephone B (0755-2001), which is attached to voice Router B in City B over a frame relay
network. The two routers both operate in the Huawei-compatible mode. Router A serves as data
circuit-terminating equipment (DCE) and Router B serves as data terminal equipment (DTE).
Figure 101 Network diagram
Configuration procedure
1. Configure Router A:
# Create a new frame relay class VoFR and set the maximum amount of voice bandwidth.
<RouterA> system-view
[RouterA] fr class vofr
[RouterA-fr-class-vofr] voice bandwidth 32000 reserved
[RouterA-fr-class-vofr] quit
"Configuring VoFR packets to carry a sequence
Figure 101, Telephone A (010-1001) attached to voice Router A in City A communicates
Command
voice-setup
vofr frf11-timer time
Command
display fr vofr-info [ serial
interface-number [ dlci-number ] ]
[ | { begin | exclude | include }
regular-expression ]
320
Remarks
N/A
Optional.
The default is 30 seconds.
number."
Remarks
Available in any view.