Configuring Mp Through An Mp-Group Interface - HP MSR Router Series Wan Access Configuration Manual

Step
3. Set the binding mode.
4. (Optional.) Set the maximum
number of links in an MP
bundle.
5. (Optional.) Set the minimum
number of links in an MP
bundle.
6. Set the minimum size of MP
fragments.
7. Configure the MP sort buffer
size factor.
8. (Optional.) Configure the
timer for MP to wait for the
expected fragment.
9. (Optional.) Disable MP
fragmentation.

Configuring MP through an MP-group interface

Step
1. Enter system view.
2. Create an MP-group interface
and enter its view.
3. (Optional.) Set the maximum
number of links in an MP
bundle.
4. Set the minimum MP packet
size for fragmentation.
5. Configure the MP sort buffer
size factor.
Command
ppp mp binding-mode
{ authentication | both | descriptor }
ppp mp max-bind max-bind-num
ppp mp min-bind min-bind-num
ppp mp min-fragment size
ppp mp sort-buffer-size size
ppp mp timer lost-fragment seconds
ppp mp fragment disable
Command
system-view
interface mp-group mp-number
ppp mp max-bind max-bind-num
ppp mp min-fragment size
ppp mp sort-buffer-size size
23
Remarks
By default, both the username
and the descriptor are used for
MP binding.
The default setting is 16.
The default setting is 0, which
means MP dialup depends on
traffic detection.
This command is available only in
dialer interface view.
The minimum number cannot be
greater than the maximum
number set with the ppp mp
max-bind command.
The default setting is 128 bytes.
The default setting is 1.
By default, the timer is 30
seconds.
By default, MP fragmentation is
enabled.
When this command is
configured on an interface, the
ppp mp lfi enable and ppp mp
min-fragment commands do not
take effect on the interface.
Remarks
N/A
If the MP-group interface already
exists, you enter its view directly.
The default setting is 16.
For this command to take effect on
an MP bundle, you must re-enable
all the physical interfaces in the MP
bundle by executing the shutdown
command and then the undo
shutdown command.
The default setting is 128 bytes.
The default setting is 1.