Configuration Examples; Lacp Mad-Enabled Irf Configuration Example For A Two-Chassis Irf Fabric - HP 12500 SERIES Configuration Manual

Configuration examples

By default, Ethernet, VLAN, and aggregate interfaces are down. To configure these types of
interfaces, execute the undo shutdown command to bring them up.
LACP MAD-enabled IRF configuration example for a
two-chassis IRF fabric
Network requirements
Set up a two-chassis IRF fabric at the access layer of the enterprise network in
LACP MAD in the IRF fabric, because the IRF fabric has a multichassis aggregate link to Device C, an
HP device that supports extended LACP.
Figure 16 Network diagram
Configuration procedure
IMPORTANT:
For two neighboring IRF members, IRF links must be bound to IRF-port 1 on one member and to
IRF-port 2 on the other.
Configure Device A:
1.
# Assign member ID 1 to Device A and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
38
Figure 16. Configure