Managing The Device Using Cli; Access Control - Proxim ORiNOCO AP-800 Installation And Management Manual

6.7 Managing the Device using CLI

To manage the device, enter the following CLI commands.

6.7.1 Access Control

Access control using CLI allows you to enable / disable the status of HTTP/HTTPS, TELNET/SSH, SNMP. To configure, enter the
following commands.
6.7.1.1 Access Table Status
Access Table Status allows you to set the status as enable / disable. To configure, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09# configure
AP-00:7D:09(config)# management
AP-00:7D:09(config-mgmt)# ?
Possible completions:
access-ctrl
access-tbl-status
access-table
exit
http
snmp
sntp
ssh
syslog
system-information
telnet
tftp
trap-host-table
///NOTE: The symbols equal(=), Double Quotes("), Single Quotes('), Back
Slash(\), Forward Slash(/), Question Mark(?), Hyphen(-) and Blank Space
are invalid for configuring Passwords and Keys.///
AP-00:7D:09(config-mgmt)# access-ctrl
AP-00:7D:09(config-mgmt-accessctrl)# ?
Possible completions:
all-access-ctrl Disabling this blocks all Mgmt interfaces except
Serial console
exit
http-ctrl
https-ctrl
snmp-ctrl
ssh-ctrl
telnet-ctrl
AP-00:7D:09(config-mgmt-ctrl)# all-access-ctrl enable
AP-00:7D:09(config-mgmt-ctrl)# https-ctrl enable
Changes in https ctrl requires reboot.
AP-00:7D:09(config-mgmt-ctrl)# http-ctrl enable
Changes in http ctrl requires reboot.
AP-00:7D:09(config-mgmt-ctrl)# snmp-ctrl enable
Changes in snmp access ctrl requires reboot.
AP-00:7D:09(config-mgmt-ctrl)# ssh-ctrl enable
Changes in ssh ctrl requires reboot.
AP-00:7D:09(config-mgmt-ctrl)# telnet-ctrl enable
Changes in telnet access ctrl requires reboot.
AP-00:7D:09(config-mgmt-ctrl)#exit
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09(config-mgmt)# access-tbl-status ?
Possible completions:
<enable(1)/disable(2)>
Table
AP-00:7D:09(config-mgmt)# access-tbl-status enable
Changes in access table status requires reboot.
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
Device Configuration, Management and Monitoring using CLI
Access Control Configuration
To enable or disable the Management Access Table
Access Table Configuration
Exits Back to Global Configure Mode
Http Configuration
SNMP Configuration
SNTP Configuration
SSH Configuration
Syslog Configuration
System Information Configuration
Telnet Configuration
TFTP Configuration
Trap Host Table Configuration
Exits Back to Global Configure Mode
To enable/disable the HTTP access
To enable/disable the HTTPS access
To enable/disable the SNMP access
To enable/disable the SSH access
To enable/disable the TELNET access
To enable or disable the Management Access
173