Bootloader Cli - Proxim ORiNOCO AP-800 Installation And Management Manual

Bootloader CLI

The Bootloader CLI provides you the ability to configure the initial setup parameters as well as download a software image to
the device.
This interface is only accessible through the serial interface, and used when:
•
The device does not contain a software image
•
An existing image is corrupted
•
An automatic (default) download of image over TFTP has failed
The Bootloader CLI supports the following commands.
•
factory_reset: Restores the factory settings
•
help: Prints online help
•
reboot: Reboots the device
•
set: Sets the parameters
•
show: Shows the parameters
The Bootloader CLI supports the following parameters (for viewing and modifying).
•
ipaddr: IP Address
•
systemname: System Name
•
gatewayip: Gateway IP Address
•
serverip: Server IP Address
•
ipaddrtype: IP Address Type
•
netmask: Net Mask
•
filename: Image file name (including the file extension)
If the Bootloader fails to load the firmware from flash, it tries to get the firmware from the network. While trying to get
firmware from the network, the device should be powered on by using ethernet interface. The default configuration of the
Bootloader parameters are as follows:
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Parameter
ipaddr 169.254.128.132
netmask 255.255.255.0
gatewayip 169.254.128.133
systemname systemname
serverip 169.254.128.133
filename imagename
ipaddrtype dynamic
Value
C
220