Proxim ORiNOCO AP-800 Installation And Management Manual page 153

PSK Security
To configure the PSK authentication mode, enter the following CLI commands.
WEP Security
To configure the WEP authentication mode, enter the following CLI commands.
Configured Security Profiles
To view the configured security profiles in different authentication modes, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-sec)# security-profile
AP-00:7D:09(config-sec-tbl)# rowadd 0 entry-status create
AP-00:7D:09(config-sec-tbl)# rowadd 0 profile-name psk_sec
AP-00:7D:09(config-sec-tbl)# rowadd 0 authentication-mode psk
AP-00:7D:09(config-sec-tbl)# rowadd 0 encryption-type wpa-tkip
AP-00:7D:09(config-sec-tbl)# rowadd 0 psk 0123456789963852
Pre-shared Key is configurable only in AP mode.
AP-00:7D:09(config-sec-tbl)# rowadd 0 rekey-interval 902
Rekeying Interval is configurable only in AP mode.
AP-00:7D:09(config-sec-tbl)# rowadd 0 entry-status create
AP-00:7D:09(config-sec)# security-profile
AP-00:7D:09(config-sec-tbl)# rowadd 0 entry-status create
AP-00:7D:09(config-sec-tbl)# rowadd 0 profile-name wep_sec
AP-00:7D:09(config-sec-tbl)# rowadd 0 authentication-mode wep
AP-00:7D:09(config-sec-tbl)# rowadd 0 key1 0123456789789456
AP-00:7D:09(config-sec-tbl)# rowadd 0 entry-status create
AP-00:7D:09# show security security-profile
// SECURITY WIRELESS PROFILE CONFIGURATION //
INDEX 1
Profile Name : AP Security
Authentication Mode : none
Encryption Type : none
Psk : ******
key 1 : ****** (wep key)
Rekey Interval : 43200
Entry Status : enable
INDEX 2
Profile Name : wep_sec
Authentication Mode : wep
Encryption Type : wep
Psk : ******
key 1 : ******
Rekey Interval : 43200
Entry Status : enable
INDEX 3
Profile Name : psk_sec
Authentication Mode : psk
Encryption Type : wpa-tkip
Psk : ******
key 1 : ******
Rekey Interval : 902
Entry Status : enable
INDEX 4
Profile Name : dot1x_sec
Authentication Mode : dot1x
Encryption Type : wpa2-aes
Psk : ******
key 1 : ******
Rekey Interval : 904
Entry Status : enable
Device Configuration, Management and Monitoring using CLI
153