Telnet/Ssh - Proxim ORiNOCO AP-800 Installation And Management Manual

4.3.2 Telnet/SSH

Configure the following parameters in the Telnet/SSH screen:
1. Password: Specifies the password to access the device by using CLI. By default, the password is set to public. To
configure, enter a new password in the Password box. The password should be alphanumeric with minimum of 6
and maximum of 32 characters.
: Special characters like - = \ " ' ? / space are not allowed in the password.
2. Telnet: Select Enable or Disable from the Telnet drop down menu. If enabled, it allows the user to access the device
through the Telnet interface.
3. Telnet Port: Specifies the port number for the Telnet interface. By default, the Telnet Port number is 23. To
configure, enter a new port.
4. Telnet Sessions: Specifies the number of Telnet sessions which controls the number of active Telnet connections. By
default, the number of Telnet Sessions allowed is 2. To configure, enter a value ranging from 0 to 3.
5. SSH: Select Enable or Disable from the SSH drop down menu. If enabled, it allows the user to access the device
through the SSH Interface.
6. SSH Port: Specifies the port number for the SSH interface. By default, the SSH Port number is 22. To configure, enter
a new port.
7. SSH Sessions: Specifies the number of SSH sessions which controls the number of active SSH connections. By default,
the number of SSH Sessions allowed is 1. To configure, enter a value ranging from 0 to 3.
8. Click OK and then reboot the device for the changes to take effect.
:
• The sum of Telnet and SSH sessions cannot be more than 3.
• The Telnet and SSH Port should not be same.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 4-14 Telnet/SSH
Device Management Using Web Interface
105