Proxim ORiNOCO AP-800 Installation And Management Manual page 107

— Security Level: Specifies the security level of the device. The supported Security Levels for the device are
None, AuthNoPriv and AuthPriv. To configure, select AuthNoPriv for Extensible Authentication, or AuthPriv for
both Authentication and Privacy (Encryption), from the drop down menu.
— Priv Protocol: Specifies the type of privacy (or encryption) protocol. By, default Priv Protocol is AES-128. To
configure, select the encryption standard as either AES-128 (Advanced Encryption Standard) or DES (Data
Encryption Standard) from the drop down menu.
: Applicable only when the Security Level is set to AuthPriv.
— Priv Password: Specifies the pass key for Privacy protocol selected. The default password is public123. To
configure, enter a new password ranging from 8 to 32 characters.
: Applicable only when the Security Level is set to AuthPriv.
— Auth Protocol: Specifies the type of Authentication protocol. By default, Auth Protocol is SHA. To configure,
select the encryption standard as either SHA (Secure Hash Algorithm) or MD5 (Message-Digest algorithm).
— Auth Password: Specifies the pass key for Privacy protocol selected. The default password is public123. To
configure, enter a new password ranging from 8 to 32 characters.
3. To save the configured parameters, click OK and then Reboot the device.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Device Management Using Web Interface
Figure 4-16 SNMPv3
107