List Commands; Command Line Completion - Proxim ORiNOCO AP-800 Installation And Management Manual

6.2.5 List Commands

By using this feature, you can view a list of commands or arguments when you type the Question Mark (?) at the command
prompt. When you enter a particular character followed by ?, then the command prompt will display all the commands or
arguments related to the character that you have typed.
Below tabulated are the basic examples explaining the List Command operations in CLI.
AP-00:7D:09>?
AP-00:7D:09>s?
AP-00:7D:09>show system-information ?

6.2.6 Command Line Completion

When you enter a command and then press TAB, it displays the complete command name that you were typing or it displays
a list of commands if there are multiple matches.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09 > ?
Possible completions:
clear Clear Log Messages
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from EXEC
ping Send Echo Messages
show Show Running System Information
traceroute Trace Route to Destination
Operation
AP-00:7D:09#con<TAB>
NOTE: Press the TAB key, to complete the command.
AP-00:7D:09#configure
AP-00:7D:09(config)# m<TAB>
Possible completions:
management
monitor
AP-00:7D:09 (config)# man<TAB>
AP-00:7D:09(config)# management
Device Configuration, Management and Monitoring using CLI
Displays all the commands that are available.
Displays all the commands that start with "s".
Displays all the commands under system-information.
Management Configuration
Monitor Configuration
Basic Example
131